ISP (pinout) Honor X7D (LGN-LX3) ısp pinout

[Filesupport]

Honor X7D (LGN-LX3) ISP Pinout Guide​

This concise, SEO-friendly guide outlines the ISP (In-System Programming) connection process for the Honor X7D (LGN-LX3). Using ISP points allows technicians to perform software recovery, eMMC/UFS repair, or fix dead boot issues directly through a programmer (such as Easy JTAG, UFI Box, or Medusa Pro) without removing the storage chip.

Safety & Preparation​

Important Warning: Always disconnect the battery and power sources before soldering. Misplaced wires or short circuits can permanently damage the motherboard.

• Required Tools: Precision soldering iron, fine jumper wire, flux, microscope, and a compatible ISP programmer.
• Pre-Check: Use a multimeter to verify that VCC and VCCQ lines are not shorted to the ground (GND) before connecting power.

Honor X7D (LGN-LX3) ISP Connection Steps​

1. Disassemble the Device: Carefully remove the back cover, disconnect the battery and screen flex cables, and take the motherboard completely out of the housing.
2. Locate ISP Points: Inspect the board near the eMMC/UFS storage chip to locate the test points: DAT0, CMD, CLK, GND, and VCC/VCCQ.
3. Solder Jumper Wires: Solder fine wires from your programmer to the corresponding board pads:
   
   • DAT0 -> Data 0 line
   • CMD -> Command line
   • CLK -> Clock line
   • GND -> Ground
   • VCC / VCCQ -> Power supply lines
4. Test Connection: Connect the programmer to your PC, open the software, and click "Identify" to verify stable communication with the storage chip.
5. Read / Write Dump: Perform your required backup, factory dump flashing, or partition repair. Once finished, carefully desolder the wires and clean any residue.

Would you like detailed instructions on using a specific tool (like UFI Box) for reading dumps on this model?